Product Description:

Funkel Technology independent research and development of oxygen sensor failure simulation equipment, support the market mainstream oxygen sensors and controllers, easy to use, cost-effective, a number of OEMs and testing organisations to use. Can be applied to PVE test, OBD development and so on.

Product Advantage:

1. support for simulation of many types of oxygen sensors: Bosch LSF, Bosch LSU4.2, LSU4.9, LSU5.1, LSU5.2, ADV, Delphi OSL, Delphi OSP, NTK switch oxygen, NTK-U3, etc.

2. Many types of testing chips are supported, including Bosch CJ125, CJ135, Delphi ECU measurement chips, Continental measurement chips, etc.

3.easy to use, through the screen to set the fault simulation parameters, without the need for external computers; wiring harness directly connected to the vehicle oxygen sensor, or connected to the ECU wiring harness adapter box; you can achieve the original signal and the simulation of the signal after the parameter comparison.

4. strong compatibility, a product compatible with a variety of oxygen sensors and chips, through the screen to set the line oxygen or switch oxygen

Product Parameters:

Linear oxygen simulation parameters

Pump current control accuracy: ±10uA

Support aging simulation type: LowPass (single-sided, bilateral configurable)

Delay(single side, double side can be configured)

Offset (offset + multiplier)

Amplitude Limit

Support all pin electrical fault simulation (short circuit to ground, short circuit to power, open circuit)

Switching Oxygen Simulation Parameters

Voltage control accuracy: ±5mV

Support aging analogue type: LowPass (single side, double side can be configured)

Delay(thick delay)

Offset(Offset+Multiplier)

Amplitude limitation

Support all pin electrical fault simulation (short to ground, short to power, open)